Problem with Wired Hoverballs + Expression1 CPU

[123justin321]

Hi there,

I'm facing a little problem. As the threadtitle says, it's about wire-hoverballs and expression1-cpu.
At Line1, I enter "A==1 ->H=85;" at Line2 "B==1 ->H=-116;". "H" means the Hoverballs height (SetZtarget).

When I wire up everything, thinks work great except that the hoverballs move a lot too fast (they are so fast that I'm thrown into the air few meters when it stops at height 85).
Is there anyway to set the moving speed of the hoverballs? I tried different values on "ZVelocity" and the speed-slider when creating the hoverballs, but without any result. No matter what value I set for both of those parameters, the hoverballs keep going as fast as hell.

Any suggestions?

regards
PS: If my english sucks, forgive me, I'm german :D

[whosdr]

Smoother gate.

[123justin321]

That worked, thank you.