Welcome, please help me solve this issue ASAP. I have had a model ripped and imported to 3dsmax, and the only new part about this to me is the 3dsmax part, normally I use milkshape with no problem, so I make the model the same way I would in the other program. Export it to smd, and then try to compile it. But then, I get this error
SMD MODEL sonic.smd
ERROR: model has no sequences
ERROR: Aborted Processing on 'sonic/sonic.mdl'
But in the .qc file, I stated
$sequence "idle" "sonic.mdl" fps 1
Why do I get this error if it has been defined already?
I have done this without failure in milkshape, as I said before and the reason I am not going to use milkshape to export the model is because milkshape is incompatible with 3d model outlines.
So other terms, I exported a model to a smd, and defined the line in the .qc, but still get this error.
Any help? :suicide:
[editline]16th August 2013[/editline]
Anyone?
FIXED, THE SOLUTION WAS THERE WAS AN UNEEDED COMMAND IN THE QC CODE
Sorry, you need to Log In to post a reply to this thread.
