Whats the size for a ventilation shaft in hammer guys, Thanks if you help.
You can use the character entity to compare and pick a good size.
If that's what you're asking...
No i mean the sizes (e.g. 24units wide and 54units high)
Use the ratio 16 units = 1 foot. Ventilation shafts come in all sizes and you didn't make the dimensions you wanted clear.
40x40 is the best size, seen as the texture for the vent fits perfectly.
Look at the prop for the ventilation shaft cage, when you enter/leave and you have to break with the crowbar.
Map it around that pretty much.
You also could of asked in the sticky :colbert:
Thanks Legend.
[QUOTE=Firegod522;22797965]Look at the prop for the ventilation shaft cage, when you enter/leave and you have to break with the crowbar.
Map it around that pretty much.
You also could of asked in the sticky :colbert:[/QUOTE]
The model is 40x40.
I was ninja'd.
Have a look at this page as well:
[url]http://developer.valvesoftware.com/wiki/Dimensions[/url]
Use 40x40 with metalwall045a as the texture. Use 0.15625 as the texture scale for both x and y.
[QUOTE=Miigga;22798310]Use 40x40 with metalwall045a as the texture. Use 0.15625 as the texture scale for both x and y.[/QUOTE]
You could just use fit and then copy/paste the scale from x to y or vice-versa.
In the case of that texture you can't because the texture is not just one metal plate, it's four. If you don't understand what I am trying to say here, go to Hammer and try it.
Sorry, you need to Log In to post a reply to this thread.
