PC Watercooling setup

[JC2Gamer1456]

I'm ready to order a full EK watercooling loop and I wanted to get some ideas on the loop order.

Here is the layout:

[IMG]http://i.imgur.com/o4gw6es.png[/IMG]

Thanks in advance.

[Levelog]

What case do you have? Honestly with dual GPU's and a CPU, it's going to be a bit toasty. It can be done though. And that 120 won't be of terrible use. Is there anywhere you can put a 240?

[JC2Gamer1456]

I have the 750D. I could use a 240 but it would have to take the place of the Pump and Res.

I would like to utilize a 240 but I wouldn't have a place to put the pump. I also DON'T want to have the res. on the exterior.

Here's how the placement would be with a 120x240 instead of a 120x120:

[IMG]http://s30.postimg.org/4rn9gsv4w/PC_Watercooling_map.jpg[/IMG]

[Levelog]

Are you kidding me? You can fit so much rad in the 750D. You can easily fit a 280mm rad in the front WITH the res/pump, or a 240mm rad on the bottom as long as you don't have super long res. You can also put the res between the motherboard and the optical drive bay as long as you don't have an eATX or XLATX board, as there are mounting holes right there.

[editline]4th May 2014[/editline]

Check out [URL="http://www.overclock.net/t/1430077/corsair-750d-owners-club"]this[/URL] thread for some good visuals as to what can fit where.

[JC2Gamer1456]

[QUOTE=Levelog;44723852]Are you kidding me? You can fit so much rad in the 750D. You can easily fit a 280mm rad in the front WITH the res/pump, or a 240mm rad on the bottom as long as you don't have super long res. You can also put the res between the motherboard and the optical drive bay as long as you don't have an eATX or XLATX board, as there are mounting holes right there.

[editline]4th May 2014[/editline]

Check out [URL="http://www.overclock.net/t/1430077/corsair-750d-owners-club"]this[/URL] thread for some good visuals as to what can fit where.[/QUOTE]

I do have an EATX board so mounting the Res between the MB and O-Drive isn't possible. The only good place I can think of is where I originally put it but I'm afraid it may trap air in the front restricting the airflow of the case.

I'll go take a look at that link.

EDIT:

I found this guy on the link you sent me and I REALLY like what he has done:

[IMG]http://s4.postimg.org/4wb11zyhp/d8fa3446_sy77.jpg[/IMG]

[Levelog]

Yeah. It's definitely a tighter fit with an eatx. The 750D is on the small side for full towers. There are a lot of impressive builds in that thread. They all make me feel bad.

[JC2Gamer1456]

[QUOTE=Levelog;44724128]Yeah. It's definitely a tighter fit with an eatx. The 750D is on the small side for full towers. There are a lot of impressive builds in that thread. They all make me feel bad.[/QUOTE]

I think I'm going to try and go for a build exactly like the one I posted above, except in blue :dance:

It's a lot better than my original build and loop order. I like how he has water going through a radiator before it hits any major components.