• Converting a CO2 gas gun to use an external tank
    5 replies, posted
Hello all, I finally got sick of screwing around with the magazines on my G&G G980 and decided to convert one of them over to use an external tank. What sort of adapters, valves, hoses and tanks do I need to set up something basic? The G980 runs from CO2 bulbs; I have seen it done where you leave a bulb in and drill out the bottom for a schraeder valve, but this being new territory I am not sure what types of units I need to make it compatible with the most common CO2 tanks. Any advice would be appreciated. Here is the gun in question, after putting a new stock on it: [img]http://24.media.tumblr.com/65bf7641da7e4dfa6aa7bfc77191c0c0/tumblr_miqqp6I0xF1qgd3nfo1_1280.jpg[/img]
That's how I planned on doing it, Oakman. The CO2 cartridges are held in a magazine below the bolt, so I can run the hose right through the bottom of it. I basically just need to know what kind of hose and connectors to use.
Thanks much. That gives me a good basis to start doing some research.
Sorry, you need to Log In to post a reply to this thread.