Suggestion One
How about enabling the HBHF Sensor so that it can be connected to a root combiner so that I can alarm all 4 sides of the base with one system so it would go
sensor 1(north),2(south) > root combiner 1
Sensor 3(east),4(west) > Root combiner 2
root combiner 1 + 2 > root combiner 3
Root combiner 3 to RF broadcaster
that way all 4 directions could be covered easier.
Suggestion Two
How about making the HBHF sensors power output configurable so that I could set one sensor to a broadcaster and a light and audio alarm so something along the lines of
HBHF Sensor to branch (1) power in
Branch (1) out to branch(2) power in
Branch (1) power out to RF Broadcaster
Branch 2( branch out) to audio alarm
branch (2) Power out to siren light
at the moment this wouldn't work because no matter how much power is sent to the sensor it still only outputs 1 watt
The HBHF sensor will emit 1 power per person detected.
To combat this you can connect each HBHF sensor up to a AND gate with 1 input constantly being powered - the highest input is outputted.
If you wish for any one of your HBHFs to trigger something wire the AND gates up to OR gates and then the output of that to whatever you want being triggered.
Hope this helps
Another solution is to connect HBHF output into a toggle input of memory cell
Sorry, you need to Log In to post a reply to this thread.
