Hi all I'm looking for some help to improve my alarm circuit.
I've listed the current circuit and at the end is what I would like it to be able to have added to its functionality
Small Generator to Splitter
Splitter power out 1 to switch power in
Splitter power out 2 to RF Reciever
Switch power out to Electrical Branch 1 Power in
Electrical Branch 1 branch out to HBHF Sensor 1 power in
Electrical Branch 1 power out to Electrical Branch 2 power in
Electrical Branch 2 branch out to HBHF Sensor 2 power in
Electrical Branch 2 power out to Electrical Branch 3 power in
Electrical Branch 3 branch out to HBHF Sensor 3 power in
Electrical Branch 3 power out to Electrical Branch 4 power in
Electrical Branch 4 branch out to HBHF Sensor 4 power in
Electrical Branch 4 power out empty
HBHF Sensor 1 power out to XOR Switch 1 Input A
HBHF Sensor 2 power out to XOR Switch 1 Input B
HBHF Sensor 3 power out to XOR Switch 2 Input A
HBHF Sensor 4 power out to XOR Switch 2 Input B
XOR Switch 1 power out to RF Broadcaster
XOR Switch 2 power out to RF Broadcaster
(Both Broadcasters set to same frequency)
RF Receiver 1 power out to Electrical branch 5
Electrical Branch 5 branch out to Audio Alarm power in
Electrical power out to Siren Light Power In
then opposite the base's main gate/door
Small Generator 2 to RF Receiver 2 power in
RF Receiver 2 power out to door controller
(door controller open and closes a door behind which is an auto turret)
(all receivers are set to the same frequency as the broadcasters)
This circuit sounds an alarm and flashes a light no matter which direction
the base is approached from it also sends a signal to clan pagers.
However I know it can be improved on.
what I would like is for it to have 4 flashing lights added in (one on each
wall inside the base) and the direction the raiders are detected at to flash,
the 2nd thing I like would be a better way to combine the sensor outputs
so that only one broadcaster is needed.
A couple of screenshots would really help
Do you have a pictures of your setup? That would make it easier.
its okay i've found a work around I've built some where that people can oinly approach from certain directions and just set up individual circuits. The previous way wouldn't work anyway as pagers are glitched.
Sorry, you need to Log In to post a reply to this thread.
