Very hilariously-built pipe. Like a "I just looked at a bong but was confused as to where the bowl goes and where you inhale and whether or not you need water"-type of deal.
One time my friend emptied my double chambered one without telling me, and I was already high so the lack of sound didn't alert me that something was wrong.
Long story short I shotgunned a full two chambers that had no filtration at all. Needless to say my lungs weren't very happy with me.
Alright so after spending 30 minutes on trying to make a new double-chambered bong, I yet have been successfull in sealing the holes where the tubes are, which result in water-leaking (there's not a significant air-leak).
So I'm asking, how do you make your holes and how do you seal them? (I don't have clay)
Hmm, honestly the only thing I ever use is clay. Assuming you're using plastic, cut a hole smaller then whatevers going in, heat it up with a lighter, and jam it through.
It should seal itself because the melted plastic would harden around it, but I'm not sure on that
Would hot-glue work?
I tried it once, but the water just pushed the glue out and dripped out. I woke up with a nice smelly puddle of bong water on my floor.
Yo Lamb, what kind of clay does good with homemade bongs?
Really anything childrens clay works for me. All the clay I've used was modeling clay, so it's easy to use it without having to play with it to get it soft.
[QUOTE=Lambadvanced;23018762]Really anything childrens clay works for me. All the clay I've used was modeling clay, so it's easy to use it without having to [B]play with it to get it soft.[/B][/QUOTE]
Just sayin'.
Sorry, you need to Log In to post a reply to this thread.
