3Ds max - Exporter (How to)

Anyone know how to export a SMD file in 3Ds Max? I know that Milkshape can but I don’t know how to do it in 3Ds max.

If that is what you are looking for. There is no SMD export plugin for 2013, only 2012 and lower. At least I looked very hard and couldn’t find any. I had to switch from 2013 and install 2012 all over again, but it was worth it. Anyways, best of luck to you.

Thats my problem I guess.

The question about a SMD Exporter in Max 2013 comes up a lot… and for some reason everyone answers incorrectly.

You can export SMDs with Max 2013.

Even though you can manually export SMDs with the SMD exporter… it would probably be worth your time to use the all-purpose Wall Worm Model Tools to export QCs, SMDs and auto-compile the MDL files.

I will be updating Wall Worm in the next few days to week to add new support for CAT Rigs too.

You might be right, but I think that the setup in “WallWorm” is stupide.

You mean you are too stupid to [properly] set it up? Its not even difficult, and the wallworm tools are great.