$attachment help

Alright so I am trying to add an $attachment when I compile a model but I am not sure how I find the local coordinates on the model for it.

I was told to open the sdk model viewer but I can’t see where it will tell me the coordinates of a specific location on the model.

Any help?

Use the attachments tab in model viewer, select the attachment and bone, set the offset and press create qc line.

If there are no attachments it sits there and doesn’t allow me to do anything.

Make an attachment to any bone at 0, 0, 0 with 0, 0, 0 rotation and then adjust it in Model Viewer. It should have an output line near the bottom of the window with coordinates for you. Replace your temporarily line with that one after you’re satisfied with the final location.

Thank you :slight_smile: